Orion Car Audio ORION MaxxBass - Manual (Page 9)

WIRING CONFIGURATIONS
The MaxxBass ® Processor is recommended in two different configurations.
1. Front Stereo Configuration
The figure below illustrates the wiring for a front stereo configuration. One
MaxxBass
® Processor is used between the front channel source and front
speaker amplifier to increase the bass response only on the front speakers.
Implementing MaxxBass ® on the front speakers will increase the perceived
bass response of these speakers down to 30-40Hz providing a Virtual
Subwoofer. The listener will achieve better bass balance and imaging with a
rear mounted subwoofer or trunk mounted speakers with sufficient bass
response.
Front speakers
with Virtual
Subwoofer TM
Subwoofer
Front Rear
Maxx
Bass
®
In-dash
CD Receiver
Power
Amplifiers
LR
LF
RR
RF
8