Orion Car Audio ORION MaxxBass - Manual (Page 12)

INPUT
To use Speaker Level Inputs (common ground head units only), connect RCA
plugs to the front or rear speaker leads as shown.
NOTE: It is important to connect an input signal to both RCA
input jacks if a stereo amplifier is used, otherwise the
connected channel receives full range and the disconnected
channel will receive only the harmonics. Use a RCA female to
dual male “Y” cord if mono input is used.
WARNING: If you are using a source unit with bridged high
powered (or "floating ground") speaker outputs, a suitable
high to low level adapter must be used. If you are unsure
about your head unit see your local Orion dealer.
Front speakers
with Virtual
Subwoofer TM
Subwoofer
Front Rear
Maxx
Bass
®
In-dash
CD Receiver
Power
Amplifiers
LR
LF
RR
RF
11