Sylvania LD370SC8 S - Manual (Page 14)

I
NITIAL SETTING
14
EN
And select the sound input for the HDMI jack if your
TV is connected to a HDMI device.
(Refer to “HDMI Audio” on page 27.)
LANGUAGE
You can change the language (English, Spanish,
French) displayed on the main menu.
(Refer to “Language Selection” on page 14.)
DVD
You can customize some functions for the disc
playback. Make sure the player is in stop mode.
(Refer to “SETTING DVD“ section on page 37.)
Auto Channel Scan
If you switch wires (e.g., between antenna and CATV) or if you move the
unit to a different area after the initial setting, or if you restore the DTV
channel you deleted, you will need to perform auto channel scan.
Before you begin:
Make sure if the unit is connected to antenna or cable.
1
Press [SETUP] to display the main menu.
2 Use [Cursor K / L] to select “CHANNEL” , then press
[ENTER].
3 Use [Cursor K / L] to select “Autoscan”, then press
[ENTER].
Channel Channel
Autoscan
Channel List
Manual Register
Antenna
Use [Cursor K / L] to select an appropriate option, then
press [ENTER].
Autoscan Autoscan
Autoscan will rescan all channels.
This may take a while to complete.
Select the destination of "ANT.IN" jack.
Back
Air
Cable
Cable
1hour
Air
Cable Or
ANT.IN
•
•
5
When aerial antenna is connected, select “Air”.
When connected to CATV, select “Cable”.
Scanning and memorizing of channels start
automatically.
Now the system is scanning for channels, please wait.
Exit SETUP
72%
Analog channels 10ch
Digital channels 6ch
When the scanning and memorizing are completed,
the lowest memorized channel will be displayed.
Note:
• If you connect the cable system directly, contact the CATV installer.
• If you press [POWER] or [SETUP] during auto channel
scan, the setting will be canceled.
• Channel settings will be saved even if the power fails.
• If you need the English menus instead of the Spanish
or French menus you are having, press [SETUP]. Use
[Cursor K
/ L ] to select “IDIOMA” or “LANGUE”, then press
[ENTER]. Use [Cursor K / L ] to select “English”, then press
[ENTER]. Press [SETUP] to exit the main menu.
• With regard only to the digital channel, even after the
scanning is complete if you unplug the AC power cord
before turning off the unit by pressing [POWER], the
channel setting may be lost.
Language Selection
You can choose English, Spanish, or French as your on-screen language.
1
Press [SETUP] to display the main menu.
2 Use [Cursor K / L] to select “LANGUAGE”, then press
[ENTER].
3
Use [Cursor K / L] to select “English”, “Español” or
“Français”, then press [ENTER].
Language Language
Select the language for setup display.
Elija el idioma de ajuste.
Sélectionner langue écran config.
Español
Français
English
4 Press [SETUP] to exit.
•
•
•
•
5
A74GDUE_LD370SC8 S_EN.indd 14 A74GDUE_LD370SC8 S_EN.indd 14 2008/04/04 16:36:14 2008/04/04 16:36:14