Onkyo CR-515 CR-315 - Manual (Page 29)

29
Basic Operation—Continued
You can choose what name is displayed when an input source is selected so that it matches the type of component that
you’ve connected to the MD/TAPE IN, DOCK/CDR IN, or DIGITAL IN. When you connect an Onkyo
-capable
component, it’s important that you select the input source name that matches the type of component for to work
properly.
On the CR-515, you can also use the front panel con-
trols.
1 Use the [INPUT] button to select the input source
whose name you want to change.
2 Push the multi control to select “Name Select?,” and
then push it again.
3 Turn the multi control to select the new input source
name.
4 Push the multi control to confirm your selection.
Input Source Name Abbreviations
Sometimes the input source name may be displayed as a
2-letter abbreviation, as per the following table.
Changing the Input Display
1 Use the INPUT [ ]/[ ] buttons
to select the input source whose
name you want to change.
CR-515: TAPE, DOCK, DIGITAL*
(*Asian model only)
CR-315: TAPE
2 Press and hold the
[MENU/NO/CLEAR] button until
“Name Select?” flashes on the
display, and then press [ENTER].
3 Use the Previous or Next
[
]/[ ] button to select the
new input source name.
/
YES/MODE
MENU/NO/
CLEAR
ENTER
INPUT
/
Depending on the input source selected
in step 1, the input source names are
selected in the following orders:
4 Press [ENTER] to confirm your
selection.
“Complete” appears on the display.
Full name Abbreviation
CDR CR
DAT DT
DIGITAL DG
GAME GM
DOCK DC
LINE LI
LINE1 L1
LINE2 L2
MD MD
PC PC
TAPE TP
VIDEO VD
MD TAPE VIDEO
DAT
DOCK CD-R
PC
DIGITAL CD-R/dig
GAME/dig PC/dig