One for All HC-8000 - Manual (Page 9)

WWW.ONEFORALL.COM
9
- Voltage and Load: 230V~
- Degree of Protection: IP 20
- Radio Frequency: 433.92MHz
- RF Range: Typically 30m in open area.
- [email protected] (just send a blank message – you will receive an
auto reply)
- www.oneforall.com
• If you require more than 10 lights to control, you can also use the Red,
Green, Yellow and Blue keys on your remote to control lights 11-14.
Simply assign these keys to the HC Receivers as you would do a
number.
• If you experience interference, it is possible to change the code of the
Light Mode on your remote to avoid this. The default code is 1000, but
it is possible to change the code to 1001, 1002 etc up to 1015
To change the code, set the Light Mode up as you would do a normal
device, using codes 1000-1015. See the manual of your ONE FOR ALL
Universal Remote Control for details on how to set up a device.
• If you wish to control more than 14 Lights, you can assign another
mode on your remote to be a second Light Mode using a different
code (between 1000 and 1015) and you will have 14 more possibilities.
For more details see the Mode Reassignment section of your manual.
• If you should wish to reset your HC Receivers to factory defaults so you
can assign it a new number, hold down the button on the HC Receiver
until the red light starts to blink, release the button and then hold it
down again until the red light goes out.
Specification HC Receiver
Customer Service
Helpful Hints
light Control_17_TALEN_2007:light Control 19-03-2007 14:27 Pagina 9