Orion Car Audio HCCA-D1200 - Manual (Page 18)

17
© 2005 Directed Electronics, all rights reserved
Step 6 Turn up the level control corresponding to the tweeter output until you hear
slight distortion and turn back the level control slightly for an undistorted
output. Depending on your system the midrange and tweeter output may be
on the same output channels.
Step 7 Fine-tune the output level between midrange and tweeters. Refer to the
Internal Crossover Configuration section of this manual for detailed instruc-
tions.
Step 8 Repeat Steps 5-7 for the rear speakers. If you do not have rear speakers con-
tinue to Step 10.
Step 9 Set levels between the front and rear midrange and tweeters for optimum
front/rear balance.
Step 10 Turn up the level control corresponding to the woofer output until you hear
slight distortion and turn back the level control slightly for an undistorted
output.
Step 11 Fine-tune the output level between satellite speakers and the woofers. Refer
to the Internal Crossover Configuration section of this manual for detailed
instructions. If using an HP-RB1, adjust the level to the output of the woofer
to match the sonic requirements of the system.
Step 12 Enjoy your awesome Orion sound system.