Oregon Scientific RAR621 - Manual (Page 12)

EN
11
SET ALARM
1. Press to display the type of Alarm you wish to
set: Weekday or Single.
2. Press and hold again for 2 seconds. The Alarm
settings will blink.
STOP ALARM
To stop the alarm from ringing, Press .
TEMPERATURE
This product can display current, minimum, and
maximum temperature information collected by the
remote sensors and main (indoor) unit.
Outdoor data is collected and displayed every
78 seconds. Indoor data is collected and displayed every
10 seconds.
SELECT CHANNEL NUMBER
Press CHANNEL to switch between sensors 1-3.
The icon shows the selected sensor.
3. Select the hour and minute. Press or to change
settings. Press To confirm.
ACTIVATE ALARM
Press or to activate or deactivate the Alarm. "-:--"
indicates that the alarm is deactivated.
Kinetic-
wave icon
Designat-
ed
Display Remote
Display
Channel 1 Remote
Display
Channel 2 Remote
Display
Channel 3 Indoor
Display
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEM.
RAR621 English R4 OP 8/18/04, 5:29 PM 11
Black