Omron Healthcare COMFIT HEM-780 - Manual (Page 27)

3. Inflation stops and the measurement is started. When the
measurement is completed, your blood pressure and pulse rate
appear on the display.
SELECTING THE USER ID
Select your USER ID. Always use the same USER ID when taking a
measurement. The monitor stores the measurement values in the
memory by the USER ID selected. These measurement values are
used to calculate the Morning Averages and Evening Averages.
Slide the USER ID Selection Switch up or down to select USER A or B.
USING THE USER ID
When you select a USER ID the monitor can be set to take one
measurement using the Single Mode or three consecutive
measurements using the TruRead
TM Mode when you press the
START/STOP button.
NOTE: The default value is set to the Single Mode to take
one measurement.
The TruRead TM Mode takes three consecutive measurements. The
monitor will inflate, take a measurement, and deflate three times
separated by a short interval of time between each measurement.
TAKING A MEASUREMENT
27
HEM-7080-updated Sept 22.qxd 9/22/06 3:46 PM Page 27