Optimus 12-2114 - Manual (Page 11)

11
5. Insert the sleeve into the dash
and bend out all the side tabs
with a screwdriver to secure the
sleeve.
6. Reconnect the wire harness and
the antenna.
7. Slide the stereo into the sleeve
until it locks into place.
If you are securing the stereo to
an existing mounting hole in the
dash, push the mounting bolt
(covered by the mounting grom-
met) through the existing mount-
ing hole and make sure it is
secure. If the mounting bolt is
too short, attach the supplied
mounting bolt extension to it.
8. Otherwise, you can use the sup-
plied hardware to attach one
end of the supplied metal strap
to the bolt on the back of the ste-
reo. If necessary, bend the metal
strap to fit your vehicle’s mount-
ing area. Then attach the other
end of the strap to a solid metal
part of the vehicle. This strap
also helps ensure proper electri-
cal grounding of the stereo.
9. Snap the plastic collar onto the
front of the stereo.
10. Reconnect the cable to the vehi-
cle’s negative (–) battery termi-
nal.
Then install the stereo’s
faceplate (see “Installing the
Faceplate” on Page 13).
12-2114.fm Page 11 Wednesday, July 14, 1999 12:35 PM