Orion Car Audio P5.2 User Manual
Page 3
INSTALLATION
The performance of the P-Series Component Loudspeaker is directly proportional
to the quality of installation. Care taken during the installation process will be
rewarded with years of satisfying performance. If you are unsure about your
installation capabilities, please refer to your local Authorized Orion Dealer
for technical assistance. Orion dealers are trained professionals dedicated to
extracting the maximum performance out of your Orion system. If you decide to
install this speaker system yourself, please read the entire installation section
before starting your installation.
TOOLS OF THE TRADE
Listed are the majority of the tools required to perform the installation. Having
the proper tools will make the installation much easier. It is very difficult when
you get half way through the installation and discover that you require a
specific tool to get yourself through a particular part of the installation. Some
of these tools are necessities. Some make the job much easier.
• Marking Pen
• Electric Drill
•
1/
4
" Drill Bit
• Phillips Screwdriver
•
1/
8
" Drill Bit
• Volt/Ohm Meter (Optional)
•
3/
8
" Drill Bit
• Assorted Tin Snips
• Hole Saw Arbor
• Wire Cutters
• 4
11/
16
" Hole Saw (5” woofer install.)
• Wire Crimpers
• 5
5/
8
" Hole Saw (6" woofer install.)
• Wire Strippers
• 1
3/
4
" Hole Saw (for flush mount tweeter install.)
FINDING SPEAKER MOUNTING LOCATIONS
Choosing the correct speaker locations will have the greatest effect on the
sound quality of the system. There are many different considerations needed
when choosing the locations that best suit your needs. The locations must be
large enough for the speakers to fit. Care is needed to ensure that the location
you have chosen will not affect any of the mechanical or electrical operations
of the vehicle.
Determining the best location for the speakers will depend on your cosmetic
needs and your vehicle's interior. If minimal intrusion in your vehicle is
desired, factory speaker locations may be the ticket for you. Placing the
speaker in the factory location can often give very desirable results.
DOOR MOUNTING
When checking for possible speaker locations in the doors, check the
operation of the window and all assemblies. There is also a stabilizer stop bar
in between the door and the door jamb. This bar prevents the door from
opening too far. Many shade tree installers overlook this and check for
clearance only when the door is fully open.
2