Onkyo Network TX-8050 - Manual (Page 25)

En-
25
Listening to the Radio —Continued
■ Selecting Presets
To select a preset, use the number buttons on
the remote controller, the remote controller’s
CH/ALBUM [+]/[–] buttons or the receiver’s
PRESET []/[] buttons.
■ Deleting Presets
1 Select the preset that you want to delete.
See the previous section.
2 While holding down the [MEMORY] button,
press the [TUNING MODE] button.
The preset is deleted and its number disappears
from the display.
■ Name Edit
You can enter a custom name for radio preset for easy
identification. When entered, the custom name will
appear on the display.
The custom name is edited using the character input
screen.
1 Press the [SETUP] button on the remote
controller.
2 Use the arrow []/[] button to select
“2. Souce Setup,” and then press [ENTER].
3 Use the arrow []/[] button to select
“Name Edit,” and then press [ENTER].
4 Use the arrow []/[]/[]/[] button to
select a character, and then press [ENTER].
Repeat this step to enter up to 10 characters.
5 When you’ve finished editing the name and
want to store it, be sure to use the arrow
[]/[]/[]/[] button to select “OK” and
then press [ENTER]. If you fail to do this,
the name won’t be saved.
Shift
*1
:
Switches the displayed character.
(Left)/(Right):
Select these to move the cursor within the Name
input area.
Space:
Enters a space character.
Back Space
*2
:
“Back Space” moves the cursor backward one
character space. In addition, “Back Space”
deletes the character to the left of the cursor.
OK:
Specifies that the entry is complete.
Tips:
*1 You can also perform this on the remote
controller by using >10.
*2 By pressing [CLR] on the remote controller, you
can delete all characters in the input.
Notes:
• This procedure can also be performed on the receiver
by using [SETUP], TUNING []/[], PRESET []/
[], and ENTER.
• Press [RETURN] to return to the previous menu.
■ Switching the Display
When receiving AM or FM, you can press the remote
controller’s [DISPLAY] button to switch the display
between the name you specified in Name Edit and the
frequency that’s being received.