Orion Car Audio XTR1002 User Manual

Page 6

FULL FLUSH MOUNTING

Step 1: Determine where the tweeter will be mounted. Make sure there is a flat

area large enough for the tweeter and no obstructions behind the area.

Step 2: Using supplied template mark with a pen the hole needed for the tweeter.
Step 3: Be sure the hole is large enough for the tweeter housing.
Step 4: Cut the hole for the tweeter. When using factory locations, this step can be

skipped. A hole can be cut either with a pair of metal tin snips or a 2" hole
saw for soft materials or 2-1/8" hole saw for hard materials.

WARNING: Check for clearance of window mechanisms and electrical wires
BEFORE you drill.

Step 5: Install tweeter in flush mount housing.
Step 6: Connect the speaker wires observing the correct polarity.
Step 7: Install tweeter and housing in the hole cut for mounting, so that the trim

ring is flat with the front of the surface.

Step 8: Use the supplied x bracket to secure the housing to the surface.

Flush Mount

Tweeter Assembly

Tweeter
Cup

X Bracket

Tweeter

Wire

Flush Mount

Trim Ring

Wiring
Harness

Panel

Screw

Figure 2
Figura 2
Abbildung 2