Installing the tweeters – Orion Car Audio XTR1002 User Manual

Page 5

INSTALLING THE TWEETERS

SURFACE MOUNTING

Step 1: Determine the tweeter mounting location, then route the wires from the

crossover to the tweeter location.

Step 2: Place the provided template or tweeter cup against the panel and mark the

two holes at the rear of the housing.

Step 3: Drill the smaller holes using a 1/8" drill bit. These are the mounting screw

holes.

WARNING: Check for clearance of window mechanisms and electrical
wires BEFORE you drill.

Step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet

and route the speaker wire from the crossover through the grommet.

Step 5: After removing the surface mount tweeter assembly trim ring, route the

tweeter wires through the larger hole in the housing and connect to the
speaker wires from the crossover.

Step 6: Insert the excess speaker wire into the hole and position the housing so the

housing will not pinch the wires after final mounting.

Step 7: Attach the housing using the supplied screws of the correct length for a solid

mount.

Step 8: Insert the tweeter into the housing and attach the surface mount trim ring.

SURFACE

MOUNT

TRIM RING

MOUNTING SCREWS

SURFACE MOUNT HOUSING

TWEETER

WIRE

PANEL

WIRING HARNESS

Figure 1
Figura 1
Abbildung 1