Onkyo TX-SR404 - Manual (Page 6)

6
Front & Rear Panels
For detailed information, see the pages in parentheses.
A STANDBY/ON button (32)
This button is used to set the AV receiver to On or
Standby.
B STANDBY indicator (32)
This indicator lights up when the AV receiver is in
Standby mode, and it flashes while a signal is being
received from the remote controller.
C Remote-control sensor (9)
This sensor receives control signals from the remote
controller.
D STEREO button (45)
This button is used to select the Stereo listening
mode.
E LISTENING MODE [ ]/[ ] buttons (45)
These buttons are used to select the listening modes.
F Display
See “Display” on page 7.
G DISPLAY button (37)
This button is used to display various information
about the currently selected input source.
H DIGITAL INPUT button (33, 53)
This button is used to assign the digital inputs and to
specify the format of digital input signals.
I DIMMER or RT/PTY/TP button (41, 42)
This button is used to adjust the display brightness.
On the European model, this is the RT/PTY/TP but-
ton, and it’s used with RDS (Radio Data System).
See “Using RDS (European models only)” on
page 40.
Front Panel
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PHONES MULTl CH DVD VIDEO 1/VCR VIDEO 2 VIDEO 3 TAPE TUNER CD
MASTER VOLUME
A SPEAKERS B
1
Q N O P R S
2 3 4 5 7 8 9 J K L M 6
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PHONES MULTl CH DVD VIDEO 1/VCR VIDEO 2 VIDEO 3 TAPE TUNER CD
MASTER VOLUME
A SPEAKERS B
9
North American and Asian Models
European Models