Onkyo HT-S780 - Manual (Page 32)

32
Turning On
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PURE AUDIO PHONES MULTl CH DVD VIDEO 1 VIDEO 2
VCR
VIDEO 3 TAPE TUNER CD VIDEO
VIDEO 3 INPUT
AUDIO L R
MASTER VOLUME
A SPEAKERS B
STANDBY/ON
MUTING
PREVIOUS
MENU
GUIDE
TOP MENU
SP A / B
--/---
TAPE/AMP
M D
CDR
CABLE
ON STANDBY
DIMMER SLEEP
10 11 12
INPUT SELECTOR
REMOTE MODE
V 1 V 2 V 3
C D TAPE TUNER
DVD MULTI CH
T V VOL VOL
SAT
VCR
T V
DVD RECEIVER
C D
INPUT
+10 0 CLR
1 2 3
4 5 6
7 8 9
CH
DISC
ON
RECEIVER
STANDBY
STANDBY indicator
Turning On the AV Receiver
1 Press the [STANDBY/ON] button.
Alternatively, press the remote controller’s [RECEIVER] button followed
by the [ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
To turn the AV receiver off, press the [STANDBY/ON] button, or the remote control-
ler’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent any
loud surprises the next time you turn on the AV receiver, always turn down the volume
before turning it off.
To turn on the subwoofer, press its [POWER] switch to the ON position (not North
American models).
STANDBY/ON
Remote
controller AV receiver
or
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Have you connected a component to a digital audio input?
If you have, see “Assigning Digital Inputs to Input Sources” on
page 33.
■ Have you connected an Onkyo MD recorder or CD recorder to the TAPE IN/OUT jacks?
If you have, see “Changing the TAPE/MD/CDR Display” on
page 33.
OPT1
COAX
OUT IN
TAPE
CD recorder / MD recorder
TESTING THE SPEAKERS
To test that all of the speakers are working properly, press the remote controller’s [TEST TONE] button. The
test tone will be output by each speaker in turn and the name of each speaker will appear on the display. To turn off
the test tone, press the [TEST TONE] button again.
• If the test tone is not produced by a speaker, or it’s produced by a speaker other than that shown on the display,
you may have wired the speakers incorrectly and you should check your connections (see page 19).