Olympus MAUSB-100 - Manual (Page 7)

7
How to install
Also refer to your computer’s user manual and the manuals for any optional devices you are using.
1 Turn on the computer
<98/98 SE
ࡗInstall>
Turn on your computer’s power (and connected devices) to start Windows 98/98 SE.
2 Install the device driver/utility software
<98/98 SE
ࡗInstall>
When using the MAUSB-100 for the first time, you must first install the device driver and utility software
included on the provided CD-ROM.
Windows 98/98 SE
1. Turn on the computer, then place the provided
CD-ROM into the computer’s CD-ROM drive.
2. When the CD-ROM is recognized, the
InstallShield setup window is displayed for a few
seconds. Then, the installation window appears
automatically.
3. Click the [Next] button.
● If the window at right does not appear, refer to
“If the installation window does not appear when the
CD-ROM is loaded” (
੬
p. 9).
● If you want to cancel the installation, click [Cancel].
Note
Do NOT connect the MAUSB-100 to the
computer until installation of the device driver/
utility software is completed.
Before installation, make sure that the computer is turned on, then follow the steps below to install the device
driver and utility software on your computer.
● Note that the windows shown below may look different on your computer, depending on how your operating
system is configured.
Do not connect to the computer before installation.