Installing the crossover – Orion Car Audio CO652 User Manual

Page 7

step 5: Install tweeter in flush mount housing .

step 6: Connect the speaker wires observing the correct polarity .

step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat

with the front of the surface .

step 8: use the supplied pressure ring to secure the housing to the surface .

figure 5
figura 5
abbildung 5

Flush Mount

Tweeter

Assembly

Tweeter
Cup

Pressure
Ring

Tweeter
Wire

Flush Mount
Trim Ring

Wiring
Harness

Panel

Mid/Woofer
Wire

Wiring
Harness

Panel

InsTallInG THe CRossoVeR

step 1: find a location for the crossover away from any factory or after market electrical wires .

It is recommended to mount the passive crossover close to the amplifier .

step 2: Mount the crossover using the supplied wire ties .

step 3: Connect the wires . Make sure the speaker wires for the midrange go to the mid/

woofer output and the tweeter to the tweeter output . be sure to observe the correct
polarity . Changing the polarity of the tweeter may be necessary for optimum sound
quality .

This manual is related to the following products:

CO552