Olympus DS-333 - Manual (Page 51)

51
Connecting to your PC using the cradle
Place the recorder on the cradle
1 Insert end A of the USB cable to your PC's USB
port or USB hub.
2 Connect the end b of the USB connection cable
to the cradle.
3 Make sure that the recorder is stopped, and place
it in the cradle.
When you place the recorder on the cradle, 1insert the
recorder so its bottom slot meets the hook on the front of
the cradle (at the low end). 2Hold the top of the recorder
and push it against the cradle until it clicks.
“REMOTE” is displayed on recorder if the USB cable is
connected.
Remove the recorder from the cradle
4 Make sure that the recorder's record/play indicator
lamp isn't flashing, and remove the recorder from
the cradle.
Hold the cradle with your hand, and raise the recorder from
the top end to remove it from the hook, as shown in the
illustration.
5 Disconnect the USB connecting cable.
······················································································································································
Notes
• Do not needlessly touch the connection point on the front of the cradle (at the low end), as that may cause
damage resulting in a bad connection.
• Release the HOLD switch. (
☞ P.9)
Hook
Connecting to
Y
our PC