Getting started – Oregon Scientific 086L004438-013 User Manual

Page 5

Clock / Alarm Area:

REMOTE SENSOR (THGN122N)

GETTING STARTED

BATTERIES

REMOTE SENSOR

�

1. Alarm set
2. AM / PM icon
3. Clock signal reception
4. Low battery icon
5. Clock
6. Alarm mode icon
7. Moon phase

�

1. LED status indicator:

Blinks red during data
transmission

1. Wall mount hole
2. RESET hole
3. CHANNEL switch
4. Battery compartment

Insert batteries before first use, matching the polarity (+
and -). Press RESET after each battery change.

indicates main unit batteries are low.

NOTE Do not use rechargeable batteries. We
recommend that you use alkaline batteries with this
product for longer usage and lithium batteries in
temperatures below freezing.

The sensor collects temperature and humidity readings
approx. every 40 seconds and sends them to the
main unit. The main unit can collect data from up to
3 sensors.

To set up the sensor:
1. Remove the screws from the battery door.
2. Insert the batteries, matching the polarity (+ / -).

This manual is related to the following products:

BAR388HG