Onkyo HT-S6100 - Manual (Page 75)

75
Advanced Setup —Continued
Note:
• These settings cannot be changed while headphones
are connected or the multichannel DVD input is being
used.
Crossover Frequency
This setting only applies to the speakers that you speci-
fied as
Small in the “Speaker Configuration” on page 74.
To get the best bass performance from your speaker sys-
tem, you need to set the crossover frequency according
to the size and frequency response of your speakers
Notes:
• For a more accurate setting, look up the frequency
response in the manuals supplied with your speakers
and set accordingly.
• Choose a higher crossover frequency if you want more
sound from your subwoofer.
• These settings cannot be changed while headphones
are connected or the multichannel DVD input is being
used.
7 Use the Down [ ] button to
select “Surround,” and then use
the Left and Right [
]/[ ] but-
tons to select Small , Large , or
None .
Small: Select if the surround speak-
ers are small.
Large: Select if the surround speak-
ers are large.
None: Select if no surround speakers
are connected.
Note:
• If the Front setting in step 5 is set to
Small, the Large option cannot be
selected.
8 Use the Down [ ] button to
select “Surr Back,” and use the
Left and Right [
]/[ ] buttons to
select Small , Large , or None .
Small: Select if the surround back
speakers are small.
Large: Select if the surround back
speakers are large.
None: Select if no surround back
speakers are connected.
Notes:
• If the Surround setting in step 7 is set
to None, this setting does not appear.
• If the Surround setting in step 7 is set
to Small, the Large option cannot be
selected.
9 Use the Down [ ] button to
select “Surr Back ch,” and use
the Left and Right [
]/[ ] but-
tons to select 2ch or 1ch .
2ch: Select if two (left and right)
surround back speakers are
connected.
1ch: Select if one surround back
speaker is connected.
Note:
• If the Surround or Surr Back settings
in steps 7 and 9 are set to None, this
setting does not appear.
Continue with step 10 of the “Cross-
over Frequency” setting.
10 Use the Down [ ] button to
select “Crossover,” and then use
the Left and Right [
]/[ ] but-
tons to select a crossover fre-
quency.
Use the diameter of the smallest
speaker in your system when choosing
the crossover frequency.
*Choose the setting suitable for the speaker.
Continue with step 11 of the “Double
Bass” setting on the next page.
This setting is set automatically by the Automatic
Speaker Setup function (see page 42).
Speaker cone
diameter
Crossover
frequency
Over 8 in. 40/50/60Hz*
6-1/2 to 8 in. 80Hz
5-1/4 to 6-1/2 in. 100Hz (default)
3-1/2 to 5-1/4 in. 120Hz
Under 3-1/2 in. 150/200Hz*