Orion Car Audio HCCA1002 User Manual

Page 6

FULL FLUSH MOUNTING

step 1: Determine where the tweeter will be mounted . Make sure there is a flat

area large enough for the tweeter and no obstructions behind the area .

step 2: Using supplied template mark with a pen the hole needed for the tweeter .
step 3: be sure the hole is large enough for the tweeter housing .
step 4: Cut the hole for the tweeter . When using factory locations, this step can be

skipped . a hole can be cut either with a pair of metal tin snips or a 2" hole
saw for soft materials or 2-1/8" hole saw for hard materials .

WARNING: Check for clearance of window mechanisms and electrical wires
befoRe you drill .

step 5: Install tweeter in flush mount housing .
step 6: Connect the speaker wires observing the correct polarity .
step 7: Install tweeter and housing in the hole cut for mounting, so that the trim

ring is flat with the front of the surface .

step 8: Use the supplied pressure ring to secure the housing to the surface .

FLUSH

MOUNT

TRIM RING

FLUSH MOUNT

TWEETER

ASSEMBLY

PRESSURE
RING

TWEETER

CUP

TWEETER WIRE

PANEL

WIRING HARNESS

Figure 2
Figura 2
Abbildung 2