Installing the tweeters – Orion Car Audio HCCA1002 User Manual

Page 5

InsTallInG THe TWeeTeRs

SURFACE MOUNTING

step 1: Determine the tweeter mounting location, then route the wires from the

crossover to the tweeter location .

step 2: Place the provided template or tweeter cup against the panel and mark the

two holes at the rear of the housing .

step 3: Drill the smaller holes using a 1/8" drill bit . These are the mounting screw

holes .

WARNING: Check for clearance of window mechanisms and electrical
wires befoRe you drill .

step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet

and route the speaker wire from the crossover through the grommet .

step 5: after removing the surface mount tweeter assembly trim ring, route the

tweeter wires through the larger hole in the housing and connect to the
speaker wires from the crossover .

step 6: Insert the excess speaker wire into the hole and position the housing so the

housing will not pinch the wires after final mounting .

step 7: attach the housing using the supplied screws of the correct length for a solid

mount .

step 8: Insert the tweeter into the housing and attach the surface mount trim ring .

SURFACE

MOUNT

TRIM RING

MOUNTING SCREWS

SURFACE MOUNT HOUSING

TWEETER

WIRE

PANEL

WIRING HARNESS

Figure 1
Figura 1
Abbildung 1