Oricom PMR3000R User Manual

Page 5

Installing the batteries

This pack contains

• 2 UHF radios
• 2 belt clips
• 2 PTT headsets
• 2 Ni-Mh rechargeable battery packs
• 1 twin desk top charger
• 1 AC adaptor

Installing the batteries

Each radio uses a Ni-Mh rechargeable battery pack (supplied). Or for added
convenience you can choose to use 3 AAA alkaline batteries in each radio (not supplied).

Warnings
• Do not mix old and new batteries.
• Do not charge alkaline or non rechargeable batteries as they could explode and cause

injury.

• If you are not using the radios for an extended period remove the batteries.
For replacement Ni-MH battery packs (Order Part No. KEBT-079-1) contact Oricom
(02) 4574 8888.

1. Ensure radio is turned off. Remove the belt clip on the back.

2. Locate the clip on the battery cover. Use your fingernail to gently prise open the

battery cover and remove.

Clip

3. Insert the battery pack supplied with charge contacts facing towards you and then

replace the battery cover.

4. Plug one end of the AC power adaptor into the charging pod and then the AC adaptor

into the power socket.

5. Slide the radios into the charging pod ensuring the charging contacts line up. The red

lights on the charge pod glow when radios are properly inserted.

6. The batteries will be fully charged within 14 hours.

→