Oricom TP150 - Manual (Page 8)

7
4 Setting Up
4.1 Setting the contrast
1. Press the MENU button. The display shows “LCD CONTRAST”.
2. Press the CALL BACK button. The display shows the current contrast
setting with values between 1 and 5.
3. Press or to select the contrast level and confirm with CALL BACK
button.
4. The display now shows to “TIME/DATE”, you can refer to next section to
set the time and date or press
CID
button to exit the set-up mode.
4.2 Setting the TIME and DATE
1. Press and release the MENU button until “TIME/DATE” is shown.
2. Press the CALL BACK button. The display shows “ENTER TIME” and
the hours digit is flashing.
3. Select the current hour using the or and confirm with CALL BACK
button. The minutes will now flash in the display.
4. Select the required minutes using the or and confirm with CALL
BACK button. The display now shows “ENTER DATE” and the month
digit is flashing.
5. Select the current month using the or and confirm with CALL BACK
button. The day will now flash in the display.
6. Select the current day using the or and confirm with CALL BACK
button.
7. Exit the set-up mode using the
CID
button.
4.3 Setting country (AUSTRALIA/NEW ZEALAND) mode
The factory preset is AUS.
1. Press and release the MENU button until AUS /NZ is shown.
2. Press the CALL BACK button.
3. Select your location (AUS or NZ) by using or and confirm with
CALL BACK button.
4. Press
CID
to exit the set-up mode.
Note: Australia Recall/flash time is 100ms. New Zealand Recall/flash time is
600ms, the unit is now set up to insert 0/00 when receiving CID log in
accordance with Telecom NZ requirements.