Oricom TP150 - Manual (Page 19)

18
8. Caller ID
Important: To use Caller ID functions the CLIP symbol must be on. If the
CLIP symbol is not visible on the display, press the
CID
button once.
8.1 Receiving a Call (Can be stored up to 64 calls)
• If an incorrect, invalid or incomplete Caller ID signal is received, the display
shows -ERROR-.
• If only the caller's phone number is received, the display shows the caller's
phone number with the time and date it was received. The NEW symbol
turns on and NEW CALL LED blinks.
Notes:
1. CALL#01 means this data is stored in Caller ID memory location #01.
2. The calling time and date are immediately recorded from the real-
time clock.
• If the callers number is not available due to the caller’s restriction, the
display shows -PRIVATE CALL- with the time and date received. The
NEW symbol turns on and NEW CALL LED blinks.
• If the callers number is not available, the display will show -OUT OF
AREA- with the call’s time and date. The NEW symbol turns on and
NEW CALL LED blinks.
• If a overseas call is received, the display will show -LONG DISTANCE-
with the calls time and date. The NEW symbol turns on and NEW CALL
LED blinks.
Notes:
1. If the Caller ID memory is full, the oldest data will be removed on a first-
in/first-out basis.
2. If the Caller ID information received duplicates another call in memory,
the time/date will be updated and the “REPEAT” symbol will be lit.
3. If no key is pressed within 20 seconds, the display will display the total
call counter, new call counter, current time and date.