Oreck SIMPLY AMAZING APU255 - Manual (Page 5)

5
T o R eplace F ilter B ag
To ensure that your ORECK ELECTRIKBROOM Powerbrush
cleaner provides you with optimal performance, use only
ORECK brand bags. Replace the filter bag more
frequently when picking up fine materials such as
powders, plaster dust, ashes and soot. These materials
may seal the filter bag before it appears full.
STEP 1: Remove Filter Bag Assembly
Remove the filter bag assembly by:
A) Grasping its top and pushing down.
B) Pulling top of filter bag assembly out and away from
the cleaner.
STEP 2: Remove Used Filter Bag
Remove used filter bag by grasping the cardboard collar
and pulling it past the raised locking tabs on the dirt tube.
Discard used bag.
STEP 3: Install New Filter Bag
Install new filter bag by pushing cardboard collar past
locking tabs on the dirt tube. Make sure the filter bag is
fully extended and tucked into the filter bag assembly.
WARNING: Unplug cord from electrical
outlet before servicing.
BAG ASSEMBLY
STEP 4: Replace Filter Bag Assembly
Replace bottom of the filter bag assembly into the side of
the cleaner. While pressing down, pivot top of filter bag
assembly in until to catch snaps into place.
To order:
Replacement Filter Bags
Part No. OR162
Call your authorized ORECK Service Center, your
authorized ORECK dealer, or the Service Center Hotline
toll free at:
US: 1-800-989-3535
CANADA: 1-800-393-8801
IMPORTANT: Do not operate cleaner
without filter bag in place.
Damage to the motor will occur.
2
1
2
1