Omron Healthcare HEM-630 - Manual (Page 8)

8
How to Apply the Wrist Cuff
Wrap the Wrist Cuff.
1. Place the wrist cuff over
your left wrist with your
left thumb facing upward.
2. Hold the bottom part of the wrist cuff and wrap it around
the wrist while pulling so that it fits snugly.
* Unless the wrist cuff is wrapped snugly, correct measurement
may not be possible.
* The remaining part of the wrist cuff can be conveniently folded back
out of the way.
* For the slender wrist (wrist circumference of less than 145 mm), the wrist
cuff may not be wrapped snugly and give a feeling of loose wrap. In this
case, do not force to wrap since the measurement is not affected.
* Fasten the Velcro tape tightly by closely adhering both sides.
When measuring
on the right wrist
Measurement can also be made
on the right wrist. Fit the monitor
as shown in the Figure.
* Wrap the wrist cuff over bare skin.
* Be sure not to roll in the sleeve
of your cloth into the wrist cuff.
* As shown in the Figure, cover
the wrist cuff by leaving
a space of 10 to 15 mm
(a space almost equal
to the width of an index
finger) between the edge
of the wrist cuff and the
border of arm and the
palm of a hand.
10 - 15 mm