Omron Healthcare HEM-630 - Manual (Page 11)

11
How to Take a Reading
Display of pulse rate
Alternating
display
2. Measurement is over and blood pressure values, pulse,
time, and date are displayed.
When the measurement is over, a mark flashes, and the cuff deflates
automatically. Then a mark turns on and blood pressure and time
are displayed alternately, and pulse rate and date are displayed alternately.
* If a measurement cannot be made or the blood pressure values are displayed
abnormally high (low), refer to Page 28.
* If the Velcro tape comes off during the measurement, wrap the wrist cuff
snugly as shown in Page 10 and measure again after fastening the Velcro tape.
3. Turn off the power.
Blood pressure measurement is complete now.
Press the START/STOP button to turn off the power.
To make another measurement, repeat the procedure in Step 1 above.
* Even if you forget to turn
off the power, the monitor
will turn off automatically
in approximately 2 minutes.
Display of measurement results
SYS mmHg
DIA mmHg PULSE/min