Optoma 1080p DLP - Manual (Page 13)

English
13
Installation
Powering On the Projector
1. Remove the lens cap. 
2. Ensure that the power cord and signal cable are securely
connected. The Power LED will turn red.
3. Turn on the lamp by pressing “ ” button on the control
panel. And the Power LED will turn blue.
The startup screen will display in approximately 30 seconds.
The first time you use the projector, you can select your
preferred language from quick menu after the startup screen
display.
4. Turn on your source (computer, notebook, video player,
etc.). The projector will detect your source automatically
within “Setup” menu, check that “Source Lock” has been set
to “Off”.
▀ ■ If you connected multiple sources at the same time, press the
“Source” button on the control panel or direct source key on
the remote control to switch between inputs.
Powering On/Off the Projector
Turn on the projector
first and then select the
signal sources.
2 1
N
ote
N
ote