Outback Power Systems OMEGA 300 - Manual (Page 22)

22
L. Troubleshooting
Problem Possible Cause Solution
Burner will not light using the
ignition system LP gas cylinder is empty Replace with full cylinder
Faulty regulator Have regulator checked or replace
Obstructions in burner Clean burner
Obstructions in gas jets or gas hose Clean jets and gas hose
Electrode wire is loose or disconnected on
electrode or ignition unit.
Reconnect wire
Electrode or wire is damaged Change electrode and wire
Faulty pushbutton ignitor Change ignitor
Burner will not light with a match LP gas cylinder is empty Replace with full cylinder
Faulty regulator Have regulator checked or replace
Obstructions in burner Clean burner
Obstructions in gas jets or gas hose Clean jets and gas hose
Low flame or flashback (fire in
burner tube— a hissing or
roaring noise may be heard) LP gas cylinder too small Use larger cylinder.
Obstructions in burner Clean burner
Obstructions in gas jets or gas hose Clean jets and gas hose
Windy conditions. Use BBQ in a more sheltered position
Gas valve knob difficult to turn Gas valve jammed Replace gas valve
For reference and correspondence,
record your serial number here.
(See sticker on side of barbecue body.)
Serial No.
__________________
This number may be required when
ordering spare parts or accessories. A
part reference number may also be
required where applicable.
Published October 2005’