Onkyo CR-L5 - Manual (Page 18)

18
Powering Up and Setting the Clock— Continued
If you cannot set the clock by using the ACCUCLOCK
function, you can set it manually. In this case, the ACCU-
CLOCK function will not automatically update the clock
each day.
You can set the clock while the CR-L5 is on or in Standby.
1
Press the [TIMER] button.
“Clock” appears on the display, as shown.
If the clock has already been set, a timer option appears
instead. In this case, you’ll need to press the [TIMER]
button repeatedly until “Clock” appears.
2
Press the [ENTER] button and use the
Up/Down [ ]/[ ] buttons to select
“Manual Adj.”.
3
Press the [ENTER] button.
The day of the week flashes.
4
Use the Up/Down [ ]/[ ] buttons to
select a day.
5
Press the [ENTER] button.
The time flashes.
6
Use the Up/Down [ ]/[ ] buttons to
set the time.
You can use the number buttons to enter the time. For
example, to enter 19:03, press [1], [9], [10/0], and [3].
Use the [DISPLAY] button to toggle between 12- and
24-hour formats.
While the 12-hour format is selected, use the [>10] but-
ton to toggle between AM and PM.
7
Press the [ENTER] button to set the
clock.
The seconds indicator starts flashing, as shown.
Note: To cancel this procedure at any point before step 7,
press the [TIMER] button.
Setting the Clock Manually
ON STANDBY
ENTER
TONE
TIMER
DIRECT
SLEEP VOLUME
UP
DOWN CLOCK CALL
DIMMER DISPLAY
CDR
C D
TAPE
PLAY MODE
REPEAT
CLEAR
MUTING
1 2
▼ ▲
3
4 5 6
7 8 9
▲
▼
INPUT
10/0 >10
Number
buttons
>10
TIMER
ENTER
DISPLAY