Onkyo TX-SR803/803E - Manual (Page 83)

83
Zone 2 —Continued
If you’ve connected your Zone 2 speakers to this AV
receiver, as explained in “Using Only Speakers in
Zone 2” on page 82, you must set the “Powered Zone 2”
setting to “Act” (Activated) as explained here.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
Powered Zone 2 Setting
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “8. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “Powered
Zone2,” and use the Left and
Right [
]/[ ] buttons to select:
Not Act: ZONE 2 SPEAKERS termi-
nals not activated.
Act: ZONE 2 SPEAKERS terminals
activated.
When Act is selected and Zone 2 is
turned on, the speakers connected to the
ZONE 2 SPEAKERS terminals will
output sound, but the speakers con-
nected to the SURROUND BACK
SPEAKERS terminals will not. When
Zone 2 is turned off, even if Act is
selected, the surround back speakers
will work as normal.
4 Press the [SETUP] button.
Setup closes.
RECEIVER
ENTER
ENTER
ENTER
ENTER
8.Hardware Setup
------------------------
a.PoweredZone2:NotAct
b.TV Format :Auto
c.AM Freq. Step: 9kHz
d.Remote ID :1
a.PoweredZone2:NotAct
Using Zone 2
1 To turn on Zone 2 and select an
input source, press the [ZONE 2]
button repeatedly.
Alternatively, press the [ZONE 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on, the ZONE 2 indicator
lights up, and the ZONE 2 12V TRIG-
GER OUT goes high (+12 V).
To select AM, FM, or XM (North
American model only), press the
[TUNER] input selector button repeat-
edly.
To select the same source as that of the
main room, press the [ZONE 2] button
repeatedly until “Zone 2 Sel: Source”
appears.
2 To turn off Zone 2, press the
ZONE 2 [OFF] button.
OFF TONE ZONE 2
ZONE 2 LEVEL
PHONES STEREO DIMMER MEMORY
LISTENING MODE
TUNING MODE SETUP
PRESET PRESET TUNING
RETURN ENTER SETUP MIC
VIDEO S VIDEO DIGITAL
VIDEO 4 INPUT
AUDIO L R CLEAR
STANDBY/ON
STANDBY
MASTER VOLUME
PHONO
ZONE 2
DISPLAY PURE AUDIO TUNER TAPE VIDEO 4 VIDEO 3 VIDEO 2 VIDEO 1 DVD MULTI CH CD
OFF ON
POWER
1 2
ZONE 2
OFF