Oricom ECO5100 - Manual (Page 26)

CORDLESS HANDSET OPERATION
23
Registration Registration
Register new handsets on the eco5100 base
The handsets which come in the same pack are already registered to the base. If you
buy new handsets. You need to register them before use.
1 . Charge the batteries (for 15 hours).
2 . Register the handset (to the base unit).
Each base can register up to 4 handsets.
During standby mode,
1
. Press and hold key on the base unit for 10 seconds.
The In Use light will flash.
2
. Press key and then press or
key to select “ REGISTER ” from the display.
3
. Press key. The display on the right is shown.
4
. Press 1, 2, 3 or 4. The handset begins to search for
the base.
5
. Press key to confi rm.
6
. When the handset locates the base, “ PIN? ” will be displayed. Enter the 4 digit base
PIN code “ 0000 ” and press the key to confi rm.
7
. Press key to confi rm and return to standby mode.
8
. LCD screen will display HS 1,2,3 or 4 and antenna icon will not fl ash.
Note: If the base is full and cannot add any more handsets, you will hear a tone.
See the next section to remove a handset.
Remove handsets
During standby mode,
1
. Press key.
2
. Press or key to select “ REMOVE
HS ” from the display.
REGISTER
BS ?
REMOVE HS