One for All Univeral Remote - Manual (Page 8)

W W
Problem & Solution
Problem:
Your brand is not listed
in the code section?
The ONE FOR ALL does
not operate your
device ?
The ONE FOR ALL is not
performing commands
properly?
Problems changing
channels?
The ONE FOR ALL does
not respond after
pressing a key?
The red light does not
blink when you press
a key?
Solution:
Try the search method on page 7.
A) Try all the codes listed for
your brand. B) Try the search
method on page 7.
You may be using the wrong
code. Try repeating the Direct
Set-Up using another code listed
under your brand or start the
search method over again to
locate the proper code.
Enter the programme number
exactly as you would on your
original remote.
Make sure you are using new
batteries and are aiming the one
for all at your device.
Replace batteries with 2 fresh,
new “AA” alkaline batteries.
8
W W W.ONEFORALL.COM
Quick Code Reference
Write down the code for your device in the boxes below and in the
battery compartment for quick and easy reference.
Brand Code
1._________________________
■■ ■■ ■■ ■■
If yo
univ
sect
assis
You
Our
- 24
- no
- pa
- inf
Bef
the
Wha
1
2
3
Devi
TV
Typ
own
4.
(*)
(**)
(***
Depending on the functions of your original remote control, the ONE FOR
ALL may operate the colour and brightness settings of your television.
Colour (+) = Press and release MAGIC then hold Volume (+)
Colour (-) = Press and release MAGIC then hold Volume (-)
Brightness (+) = Press and release MAGIC then hold Channel (+)
Brightness (-) = Press and release MAGIC then hold Channel (-)
Colour and Brightness
Note: You have 5 seconds to press the Volume or Channel keys for colour or
brightness adjustment after pressing MAGIC.
BIG Easy_1_ 2005 27-06-2005 14:22 Pagina 8