Orion Car Audio Cobalt CO154S - Manual (Page 5)

4 © 2007 directed electronics—all rights reserved
WIRING CONFIGURATIONS
The following illustrations provide guidelines on properly connecting your
Orion Cobalt woofer to an Orion Cobalt amplifier for maximum performance .
Recommended Amplifier Power
Continuous Power (RMS) Peak Power (Watts)
woofer 00 to 300 200 to 600
2 woofers 200 to 600 400 to 200
3 woofers 300 to 900 600 to 800
4 woofers 400 to 200 800 to 2400
Parallel—Two Speakers ( 4 ohm voice coils)
Two 4 ohm voice coil woofers with the two woofers in parallel results in a 2 ohm load
to the amplifier . .
+
+
+
4 ohm
_
_
_
4 ohm
Figure 2
Figura 2
Abbildung 2
. Connect the speaker in parallel by connecting the two positive (+) terminals
together and the two negative (-) terminals together .
2 . Wire the positive (+) terminals of the woofers to the positive (+) terminal on
the amplifier . Wire the negative (-) terminals of the woofers to the negative (-)
terminal on the amplifier .