RCA J26L637L - Manual (Page 11)

Connections and Setup
Chapter 1 11
What To Expect
Watching TV
• Remember: If you have an analog signal connected to your
ANTENNA/CABLE ANALOG INPUT, then look for an A at the
bottom of the screen to make sure you're tuned to the Analog
input. Press the ANTENNA button if the A isn't appearing.
Analog video is sent in a 4/3 format, which your TV displays these
channels in a 16/9 format. Press the LEFT/RIGHT ARROW button
to view the different formats available. Go to page 24 for more
explanation of screen formats.
• Remember: If you have a digital signal connected to your
ANTENNA/CABLE DIGITAL INPUT, then look for a D at the
bottom of the screen to make sure you're tuned to the Digital
input. Press the ANTENNA button if the D isn't appearing.
Most digital video is sent in a 16/9 format which does fi ll your
screen, but sometimes is sent in 4/3 which does not fi ll your
screen. It depends on how the station or source device is
formatting the video. If there are bars on-screen, press the LEFT/
RIGHT ARROW button to try a different format that may eliminate
the bars. Go to page 24 for more explanation of screen formats.
Changing Channels
• Digital channels can have both primary channels (like the analog
channel number) and sub-channels. First tune to the Digital Input
by pressing the ANTENNA button and look for a D at the bottom
of the screen. To tune to a digital channel with a sub-channel,
enter the primary channel number, then press the right arrow
button. Enter the sub-channel number and press OK.
• Depending upon the type of signals you have connected to your
HDTV, you might notice that the channels change slower than
you’re used to. This is perfectly normal. Digital cable channels
sometimes take longer to tune.
Look for the A at the bottom of the screen to
make sure you're on the Analog Input.
Look for the D at the bottom of the screen to
make sure you're on the Digital Input.
A 10 CBS
D 10-1 CBS
Min Stdby Power When enabled, keeps power consumption levels compliant with Energy Star
standards. The TV is shipped with this enabled. When enabled, the DSCI and Hospital Pendant
(pillow speaker jack) are disabled when power is turned off.
Legacy Mode When turned on, allows the TV to work with earlier DSCI versions. Off is the
default setting.
Info Menu Allows the master user to determine whether the Channel Banner is displayed when
the INFO button is pressed on the remote.
Page 24 shows this display.
Hospital Mode When turned on, allows the TV to function with the hospital pendant remote.
For more information about this remote, go to
page 24 .
Note: When Remote Confi g. and Front Panel are set to Disabled, the MENU button on the
master remote turns on the TV.