Radio Shack 43-3522 - Manual (Page 9)

8
Using the Cord Clip
Insert the cord into the cord clip’s
hook, then attach the cord clip to your
lapel or shirt to position the cord.
OPERATION
Making And Receiving Calls
Before using the phone, put the
headset on and adjust it as needed.
To make a call, lift the remote keypad,
then press
TALK/HANG UP . You hear a
dial tone, the TALK/LOW BATT
indicator and the IN USE/CHARGE
indicator. Dial the desired number.
To answer a call, lift the remote
keypad, then press
TALK/HANG UP .
The TALK/LOW BATT indicator and IN
USE/CHARGE indicator.
To disconnect a call, press TALK/HANG
UP or place the remote keypad on the
base.
Notes:
• When you press a button, a single
tone indicates that the phone has
accepted the command. Three
tones indicate that you pressed a
button in error or there is severe
interference. If there is severe
interference, move the remote
keypad closer to the base before
you press any key.
• If the interference is severe, the
remote keypad might lose
communication with the base and
the call might be disconnect. If this
happens, return the remote
keypad to the base for about 5
seconds to reset the security
access-protection code.
Changing Channels
Your phone has an Auto Scan feature
that automatically selects a clear
channel when you press
TALK/HANG
UP . If you experience interference
during a call, press CHANNEL to switch
to another channel until you have good
reception.
Setting the Volume
To adjust the volume, lift the remote
keypad, press
TALK/HANG UP . Then
repeatedly press VOLUME
8 8 8 8
or
9 9 9 9
.
There are four levels. The phone
beeps 3 times when you reach the
lowest or highest level. The volume
level remains set after you hang up.
Using Redial
To quickly redial the last number
dialed, lift the remote keypad, press
TALK/HANG UP then REDIAL/PAUSE .
To redial a busy number, press
REDIAL/PAUSE without returning the
phone to the base.
Notes:
• The redial memory holds up to 32
digits, so you can redial long-
distance as well as local numbers.