RCA J20F742 - Manual (Page 9)

Chapter 1 9
Connections & Setup
Place All Available Channels Into Memory
1. To go to the Setup menu, with the master remote (CRK17TD1), press
MENU then select Setup. In this menu you'll be able to set your Signal
Type. Next go to Auto Channel Search, the TV will search for all channels
viewable through your antenna or cable TV system.
2. Select which channel list you’d like to find channels for (List A is the default).
3. Press the down arrow button to select Start. Press the OK button to start
searching. The TV searches for active channels and places them in the
channel list.
Note: Video Input Channels (VID, SVID, etc.) must be added to the active
channel list separately before they can be accessed. Refer to the Setup
menu section at the end of this chapter for more information on the
Channel menu and List & Labels.
Set the Time
The current time options might not be available to the basic user, depending
on how they've been set by the master user. (The Time Configuration menu
isn't available in the basic menu).
To set the time, from the Main menu select Time then Time Config. If the
current time has not been set, use the arrow and number buttons on the
remote control to make changes.
1. From the Main menu, highlight Time and press OK.
2. Time Config. is highlighted. Press the right arrow to enter the menu.
3. Time is highlighted. To set the time press the right and left arrow button to
add or subtract minutes. Use the number buttons to set the hour. The OK
button changes am and pm.
The ClonePRO™
If several TVs need to be programmed with the same menu settings, an
optional ClonePRO remote can be used to copy all of the menu settings from
one TV into other TVs to reduce installation time. Information can be both
downloaded to and uploaded from the ClonePRO using the DSCI port on the
TV’s back panel or using the IR sensor. A ClonePRO can be obtained from your
RCA commercial distributor. Chapter 2 has information about this remote, see
page 20. If you want to set other menu options before using the ClonePRO,
continue on in this chapter. You can use the ClonePRO at any time.
Go Back
Time Config.
...
Sleep Timer 00:00
Wake-Up Timer ...
Schedule ...
TIME
Go Back
Time 08:25AM
Set Time Access Disabled...
Time Offset None....
TIME CONFIG
AUTO CHANNEL SEARCH
Go Back
Channel List
List A...
Start Running...
Channel 012
Press OK to start the
Auto channel search