RedMax HE2601 - Manual (Page 11)

Operation
The RedMax stick edger Model HE2601 is
designed for edging lawn in gardens, parks,
roadsides and so on.
Before starting the engine, take the
operating position and adjust the handle
position and the wheel height as necessary.
■ ADJUSTING HANDLE POSITION
• Loosen the handle bracket screws and re-
position the handle to your best operating
position. Re-tighten the screws.
■ ADJUSTING WHEEL HEIGHT
• Loosen the clamp lever and change the
wheel height to obtain desired cutting
depth.
• Never adjust wheel height with the
engine running.
WARNING
■ STARTING ENGINE
1. Rest the unit on a flat, firm place. Keep the
blade off the ground and clear of the
surrounding as it will start rotating upon
starting of the engine.
2. Pump the priming pump until fuel flows out
in the clear tube.
3. Move the choke lever upward to close the
choke.
4.Set the ignition switch to the “start”
position. While pulling the throttle lever,
push the set button, and release the
throttle, then the throttle lever is in to the
“start” position.
Ignition
Switch
Throttle set Button
STOP
START
❲ 9 ❳