Radio Shack Enercell 273-316 User Manual
Cautions, Fcc information, Limited warranty
TM
M
T
3 / 4.5 / 6 / 7.5 / 9 / 12VDC • 1A
AC-to-DC Power Adapter
273-316
Cautions:
•
If this adapter is not compatible with the voltage and
current requirements of your portable device, it can result
in PERMANENT DAMAGE to the device.
•
Before using, consult the User’s Guide or the rating label
on your device to make sure it requires 3 / 4.5 / 6 / 7.5 / 9 or
12 volts DC.
•
The power adapter’s current (1A) must be equal to or more
than the current needed by your portable device.
•
Before charging cell phones, make sure the cell phone
specifications are supported by this power adapter.
•
Never operate the adapter if it has been damaged in any
way. Do not disassemble it.
w
WARNING: To prevent fire or shock hazard, do not expose the
adapter to rain or other moisture.
w
CAUTION: The total combined current for accessories
plugged into this adapter must not exceed 1A.
FCC Information
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equip�
ment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Modifying or tampering with your 3 / 4.5 / 6 / 7.5 / 9 or 12VDC 1A AC�to�DC
3 / 4.5 / 6 / 7.5 / 9 or 12VDC 1A AC�to�DC
VDC 1A AC�to�DC
Power Adapter’s internal components can cause a malfunction, which might
invalidate its warranty and void your FCC authorization to operate it.
Limited Warranty
Ignition L.P. warrants this product against defects in materials and workmanship
under normal use by the original purchaser for ninety (90) days after the date of
purchase. IGNITION L.P. MAKES NO OTHER EXPRESS WARRANTIES.
This warranty does not cover: (a) damage or failure caused by or attributable
to abuse, misuse, failure to follow instructions, improper installation or mainte�
nance, alteration, accident, Acts of God (such as floods or lightning), or excess
voltage or current; (b) improper or incorrectly performed repairs by persons who
are not a Ignition L.P. Authorized Service Facility; (c) consumables such as fuses
or batteries; (d) ordinary wear and tear or cosmetic damage; (e) transportation,
shipping or insurance costs; (f) costs of product removal, installation, set�up
service, adjustment or reinstallation; and (g) claims by persons other than the
original purchaser.
Should a problem occur that is covered by this warranty, take the product and
the sales receipt as proof of purchase date to the place of purchase. Ignition
L.P. will, at its option, unless otherwise provided by law: (a) repair the product
without charge for parts and labor; (b) replace the product with the same or a
comparable product; or (c) refund the purchase price. All replaced parts and prod�
ucts, and products on which a refund is made, become the property of Ignition
L.P. New or reconditioned parts and products may be used in the performance
of warranty service. Repaired or replaced parts and products are warranted for
the remainder of the original warranty period. You will be charged for repair or
replacement of the product made after the expiration of the warranty period.
IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDITIONS
NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WARRANTIES
THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED WARRANTY
OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED WARRANTY OF
FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE ON THE EXPIRATION
OF THE STATED WARRANTY PERIOD.
EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO LIABILITY
OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY
OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR
DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE
OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY,
INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM
INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY, REVENUE, OR
PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES, EVEN IF IGNITION L.P. HAS BEEN ADVISED OF THE POSSIBILITY
OF SUCH DAMAGES.
Some States do not allow limitations on how long an implied warranty lasts or
the exclusion or limitation of incidental or consequential damages, so the above
limitations or exclusions may not apply to you. This warranty gives you specific
legal rights, and you may also have other rights which vary from State to State.
You may contact Ignition L.P. at:
Ignition L.P., 3102 Maple Ave Suite 450, Dallas, TX 75201
02/09
For product support, call 1-866-315-0426.
UsingYour Adapter
1. Plug the correct
size Adaptaplug
onto the jack at the
end of the adapter’s
cord.
•
If your device’s DC input jack is marked
, align TIP on the adapter’s jack with + on
the Adaptaplug (shown).
•
If the DC input jack is marked
, align TIP on
the adapter’s jack with – on the Adaptaplug.
w
CAUTION: Be sure to set the correct tip polarity.
Incorrect polarity can damage your device or the
adapter.
2. Plug the Adaptaplug into your device’s DC input jack.
3. Set the adapter’s voltage switch to the correct
setting.
4. Plug the adapter into an easily accessible power
outlet located near the equipment.
Protect the environment. Go to E�CyclingCentral.com
to find an electronic recycling center near you.
Printed
in China
05A09
273�316
© 2009. Ignition L.P. All rights reserved.
Enercell is a trademark used by Ignition L.P.