ResMed Full Face Mask Mirage Quattro - Manual (Page 8)

4
8 Fully unscrew and remove the dial then pull the forehead support out of the
mask frame (Fig. C-7).
9 Remove the forehead support pads from the forehead support (Fig. C-8).
10 Squeeze and push the upper side tabs on the cushion clip out of the mask
frame. Pivot away from the mask, and gently pull out (Fig. C-9).
11 Separate the cushion from the cushion clip (Fig. C-10).
12 Remove the ports cap from the mask frame (Fig. C-11).
Cleaning the Mask in the Home
Notes:
• The mask and headgear can only be cleaned by handwashing.
• The headgear may be washed without removing the headgear clips.
WARNING
• Do not use aromatic-based solutions or scented oils (eg, eucalyptus or
essential oils), bleach, alcohol or products that smell strongly (eg,
citrus) to clean any of the mask components. Residual vapours from
these solutions can be inhaled if not rinsed thoroughly. They may also
damage the mask, causing cracks.
• Do not iron the headgear as the material is heat sensitive and will be
damaged.
Daily/After Each Use
To optimise the mask seal, facial oils should be removed from the cushion
before use.
Handwash the mask by gently rubbing in warm (30°C) water using mild soap
or diluted dishwashing detergent.
Do not twist the valve during cleaning as this may damage or tear the valve
membrane or hinge. Take care when handling the valve.
If the vent requires cleaning use a soft bristle brush.
Rinse all components well with drinking quality water and allow them to air dry
out of direct sunlight. Do not soak the mask.
Weekly
Handwash the headgear in warm (30°C) water using mild soap or diluted
dishwashing detergent. Rinse well and allow it to air dry out of direct sunlight.
61856r3 Eng Ref.fm Page 4 Friday, March 23, 2007 2:02 PM