Raymarine Ray215e - Manual (Page 85)

4-30 Operation with Full Function Handset
4.6.18.4 Transmitting a Group Call
You can send and receive DSC calls from groups of stations that share the
same Group MMSI number.
The RAY215E can only transmit ROUTINE Group calls. As with any
DSC operation, the call is made on channel 70.
To make a Group Call:
1. Set up the Group MMSI number as outlined in Section 4.7.3.4.
2. Press the INDV key. Ind appears on the 7-segment display, the DSC
indicator is illuminated, and SHIP appears on the dot matrix display.
3. Press the SQ UP/DOWN key to alternate between SHIP, SHORE,
and GROUP. Stop on GROUP. The GROUP message only appears if
you have set up the Group MMSI number as outlined in Section 4.7.3.4.
4. When GROUP appears, press the ENT key. GrP appears on the 7-
segment display and the registered Group MMSI number appears on
the dot matrix display.
INDV ENT
Only appears if Group
MMSI number is set up
via DSC Operation in
Menu Mode
Group MMSI number
Note: Since only one group MMSI number can be registered at time, only
one MMSI number can be displayed when GROUP is selected. To change
the group MMSI number, see Section 4.7.3.4.
5. Press ENT to accept the Group MMSI number.
6. Use the SQ UP/DOWN key to select the Working Channel for
communication.
7. When the desired channel number appears, press ENT. The dot matrix
display scrolls between the Working Channel and the Group MMSI
number.
8. If this information is correct, press ENT to accept. A new message
appears, prompting you to press the PTT key.