5 • using your steam generator, 4 • operating the control panel, Synthetics (low temperature) – ROWENTA 42449 User Manual
Page 4: Silk/wool (medium temperature), Low temperature), Medium temperature)

1. Place the iron’s temperature control to the type
of fabric to be ironed (6).
•
Synthetics (low temperature)
••
Silk/wool (medium temperature)
•••
Cotton/Linen (high temperature))
2. The iron temperature control light turns on.
Be careful ! the steam generator is ready when the iron temperature control light goes out and
when the green « steam ready » light stays continuous.
3. Adjust the steam output control dial located on the control panel (7), eg : less steam for low temperatures.
Note : It is normal for the connection cord to become warm during use.
5 • USING YOUR STEAM GENERATOR
GB
• Flashing green light : the water is heating up in
the boiler.
• Continuous green light : steam is ready for
use.
• Continuous red light :
the water tank is empty.
• Orange “boiler rinse” light flashes : your boiler needs rinsing.
Note: the appliance must be cold (see section 11).
• “Restart” button:
- to be pressed briefly after each refill of the water tank to start ironing again (see section 6),
- to be held pressed for 2 or 3 seconds after rinsing the boiler (see section 11).
4 • OPERATING THE CONTROL PANEL
co
tt
o
n
-l
in
e
n
s
il
k
-w
o
o
l
s y n t
h e t i cs
M
IN
(6)
(7)
Type of fabric
Setting temperature
control
Setting steam
output control dial
c
o
tt
o
n
-l
in
e n
s i l k - w o o l
sy
n
th
e
ti
c
s
MIN
c o t t o n - l i n e n
si
lk
-w
o
o
l
s
y
n
th
e
tic
s
M
IN
•
(Low
temperature)
co
tt
o
n
-l
in
e
n
s
il
k
-w
o
o
l
s y n t
h et i cs
M
IN
••
(Medium
temperature)
•••
(High
temperature)
Synthetics
Silk / Wool
Cotton / Linen
SETTING THE TEMPERATURE CONTROL AND STEAM OUTPUT CONTROL DIAL ACCORDING TO
THE TYPE OF FABRIC TO BE IRONED: