Radio Shack 32-2059 - Manual (Page 5)

8
The Basics
9
The Basics
important safety instructions
(UL 6500)
1. Read all safety and operating instructions before the
appliance is operated.
2. Keep all safety and operating instructions for future
reference.
3. Follow all warnings on the appliance and in the
operating instructions.
4. Unplug this appliance from the wall outlet before
cleaning. Use only a damp cloth for cleaning. Do not
use liquid or aerosol cleaners.
5. Do not use this appliance near water (for example,
near a bathtub, washbowl, kitchen sink, or laundry
tub; in a wet basement; or near a swimming pool).
6. Do not place this appliance on an unstable cart,
stand, tripod, bracket, or table. The appliance may
fall, causing serious injury to a child or adult, and
serious damage to the appliance. Use only with a cart,
stand, tripod, bracket, or table recommended by the
manufacturer or sold with the appliance. Follow the
manufacturer's instructions for mounting, and use a
recommended mounting accessory.
7. Slots and openings in the cabinet provide ventilation,
ensure reliable operation, and protect from
overheating. Do not block or cover these openings,
and do not place the appliance on a bed, sofa, rug, or
other similar surface. Do not place the appliance in a
built-in installation such as a bookcase or rack unless
it provides proper ventilation as specifi ed by the
manufacturer.
8. Keep appliance away from heat sources such as
radiators, heat registers, stoves, or other appliances
(including amplifi ers) that produce heat.
features
front of equalizer
POWER on/off rocker switch with LED indicator
Press up to power your equalizer. The LED will light up. Press
down to turn your equalizer off. The indicator light will also
turn off.
equalizer IN/OUT switches
The switch on the left is for the left channel and the switch
on the right is for the right channel. Press in to activate your
equalizer. The equalizer LED indicator lights up. Press again
to defeat the equalizer function.
LOW CUT switches
The switch on the left is for the left channel and the switch
on the right is for the right channel. Press in to attenuate
the unwanted low frequency sound created by the source
equipment. The LOW CUT LED indicator lights up. Press
again to release the switch and turn off LOW CUT.
output level indicators
The indicators on the left correspond with the left channel
and the indicators on the right correspond with the right
channel. The +6/+3/0/-10 LED output level indicators light
up to indicate the output level of each side of your sound
system, from -10dB to +6dB.
output level control
The control on the left is for the left channel. The control on
the right is for the right channel. Turn to adjust the output
signal of each channel so the average output equals the input
signal level without distortion.
equalizer controls
The 15 controls on the left correspond with the left channel
and the 15 on the right correspond with the right channel.
Use these Equalizer Controls to adjust the frequency
response of each side of your sound system. Each frequency
control cuts or boosts up to ±12dB.