ROWENTA 63016 User Manual

Page 4

Laundry

Fabric

Temperature

label

setting

Synthetics

●

Nylon

(low temperature)

Polyester

Silk

●●

Wool

(medium temperature)

Cotton

●●●

Linen

(high temperature)

To avoid an automatic switch off while the iron is heating
up, always keep the iron on its heel.

Start at a low temperature and graduate to a high tempera-
ture.

For delicate fabrics we recommend carrying out a test on
an unobtrusive part of the garment (inner seam).

Steam can only be produced when the thermostat is in
the red cotton/linen zone.

ᕤ SETTING THE VARIABLE STEAM CONTROL

Set the variable steam control to
required steam volume. Steam can
only be produced when the thermo-
stat is aligned to ●●● (red zone on
dial). (If on setting ● or ●● the vari-
able steam lever should be shut off.)
Allow iron to heat up (light goes
out) before activating the steam
control.

Iron ready for steam ironing

Steam is produced as soon as the iron is held horizontally and
variable steam lever is moved from the min position.

Steam off

Steam generation can be interrupted by standing the iron on
its heel or sliding the variable steam control fully to the left
(min.)

ᕥ SPRAY SETTING

Ensure there is water in the tank.

Moistening the fabric with the
spray will make wrinkle removal
easier. This is very useful when the
three dot setting is too hot for the
material being ironed.

Press the spray button down slowly
for a jet or quickly for a mist.

Do not spray silk, etc.

min

max Clean

Self