Reliable i300 - Manual (Page 5)

There is
no steam
coming out
of the
iron? 1) The steam knob (where supplied)
might be closed
2) The iron switch might be off
3) The boiler switch might be off
4) The water might be used up. 1) Open the steam knob anticlockwise.
2) After the iron switch comes on, wait for 4
minutes so that the iron plate gets hot.
3) After the boiler switch comes on, wait for
10 minutes so the boiler produces steam.
4) Fill it following the instructions carefully.
Does the
ironing
board get
wet? 1) The ironing board cover might not
be able to absorb the steam
completely
2) The steam iron leaks steam mixed
with water (Check by spraying some
steam on a dry cloth) 1) You might use a thicker cover (or two
covers) so to create a thicker surface to
absorb the steam better. In case you are
using a vacuum table, switch on the
vacuum function each time you are using
the steam
2) See # 2
Does the
steam leak
dirty
water? Some dirty might have gone into the
tank with the water and it is given off
from the iron. Fill the empty tank with 1 liter of water,
screw the cap up, shake it, unscrew the
cap and empty the tank. Repeat the action
until the water is cleaned. We do not
recommend the use of any additive to pour
in the tank. Before ironing again spray
some steam on a cloth until clean steam
comes out.