Radio Shack 85 - Manual (Page 16)

16
Connecting Two Speakers (Unbridged Connection)
If you are connecting only two speakers, you can connect them to the amplifier’s
front (
CH1 and CH2 ) or rear ( CH3 and CH4 ) speaker terminals.
Caution: This is an unbridged connection that produces 85 watts per channel. If
you do not have high power speakers, use this connection.
1. Connect one end of a speaker wire’s marked conductor to the amplifier’s
+
CH1 (front-left positive) or
+
CH3 (rear-left positive) terminal.
2. Connect the unmarked conductor’s end to the amplifier’s CH1
−
(front-left
negative) or CH3
−
(rear-left negative) terminal.
3. Repeat Steps 1 and 2 to connect speaker wires to the amplifier’s CH2
+
and
−
CH2 (front-right) or CH4
+
and
−
CH4 (rear-right) terminals.
4. Connect the other ends of the speaker wires so CH1 (or CH3) connects to
the left speaker and CH2 (or CH4 ) connects to the right speaker.
12-1977.fm Page 16 Tuesday, July 13, 1999 10:07 AM