Radio Shack 43-3814 - Manual (Page 12)

12
Telephone Operation
SETTING THE HANDSET
VOLUME
To adjust the handset’s volume during a call,
press
8 8 8 8
or
9
on the handset until you reach
the desired volume level.
Lebkc[ýCWn_ckc Lebkc[ýCWn_ckc Lebkc[ýCWn_ckc Lebkc[ýCWn_ckc
,
Lebkc[ý>_]^ Lebkc[ý>_]^ Lebkc[ý>_]^ Lebkc[ý>_]^
,
Lebkc[ýC[Z_kc Lebkc[ýC[Z_kc Lebkc[ýC[Z_kc Lebkc[ýC[Z_kc
, or
Lebkc[ýBem Lebkc[ýBem Lebkc[ýBem Lebkc[ýBem
appears.
When you press
8 8 8 8
while the volume is
maximum or
9 9 9 9
while the volume is low, the
handset beeps and the setting does not
change.
The volume level setting is maintained even
after you hang up the phone.
USING FLASH
FLASH performs the electronic equivalent of
a switchhook operation for special services,
such as Call Waiting.
For example, if you have Call Waiting, press
FLASH to answer an incoming call without
disconnecting the current call. Press FLASH
again to return to the first call.
If you do not have any special phone
services, pressing
FLASH might disconnect
the current call.
USING REDIAL
To quickly dial the last number dialed, lift the
handset and press
REDIAL , then press TALK .
You can also press REDIAL/PAUSE after
pressing TALK .
Notes:
• The redial memory holds up to 32 digits,
so you can redial long-distance as well
as local numbers.
• The redial memory also holds pause
entries (see “Entering a Pause” on
Page 14).
USING TONE SERVICES ON
A PULSE LINE
Some special services, such as bank-by-
phone, require tone signals. If you have
pulse service, you can still use these special
tone services. Dial the service’s main
number. When the service answers, press
TONE/
6 /*. Any additional numbers you dial
are sent as tone signals.
When you hang up, the phone automatically
resets to pulse dialing.
PAGING
To page the person who has the handset or
to locate the handset when the phone is not
in use, press
PAGE on the base. The handset
beeps for about one minute. To stop it from
beeping sooner, press any key on the
handset or return the handset to the base.
Press
PAGE again to stop the paging at the
base.
USING A HEADSET
You can connect an optional headset with
a
3 / 32 -inch (2.5-mm) plug. Contact your local
RadioShack store for a suitable headset.
To connect the headset, open the rubber
cover on the side of the handset, then insert
the headset’s plug into the jack.
When you finish using the headset,
disconnect it from the handset and close the
rubber cover to protect the jack.
Notes:
• Connecting a headset disconnects the
handset’s earpiece and microphone.
•
8
or
9
on the handset also controls the
connected headset’s volume.
• If you place the handset on the base to
recharge it while the headset is