RIDGID MS1250LZ1 - Manual (Page 15)

15
ASSEMBLY
TABLE EXTENSION
See Figure 9.
The table extension can be used on the left side of the miter
saw. To assemble and install the table extension:

Insert socket head screw and washer into the two holes
in the side of the miter saw base.
 Tighten securely.
MITER LOCK HANDLE
See Figure 10.
To install the miter lock handle, place the threaded stud on
the end of the miter lock handle into the threaded hole in the
control arm under miter table. Turn clockwise to tighten.
DUST GUIDE
See Figure 11.
Insert the dust guide inside the exhaust port in the upper
blade guard. Turn the guide so that the open end is facing
down or toward the rear of the saw.
Fig. 9
15 20 25 30 35 40 45
10
TABLE
EXTENSION
SOCKET HEAD
SCREW
WASHER
WASHER
Fig. 10
MITER
LOCK
HANDLE
TO
TIGHTEN
TO
LOOSEN CONTROL
ARM
Fig. 11
UPPER
BLADE GUARD
DUST
GUIDE
EXHAUST
PORT