ritetemp 8050C - Manual (Page 8)

PG
14
PG
13
R
G
Y
W
C
RH
or
From Furna
ce
and AC unit
STEP 1 - Connect the Y wire
to the Y terminal on the
thermostat. This connects to
the Cooler compressor.
STEP 2 - Connect the RH or R wire to the RH
terminal on the thermostat.
This connects the Heater/Cooler Power.
STEP 3 - Connect the W wire to the W terminal
on the thermostat.
This connects to the heater control line.
STEP 4 - Connect the G wire to the G terminal on the Thermostat.
This connects to the Fan.
Your HVAC system is now connected to the thermostat.
Go To Page 10
4 WIRE
NON-HEAT PUMP
NOTE: Wires marked with
the dotted line are optional.
HVAC SYSTEM
jumper
wire
Heat
Power
Heat
W G RH C
FAN
Y
Cool
Comp
Thermostat
From Furna
ce
and AC unit
G
W
Y
RH
RC
C
STEP 1 - Remove the Jumper wire.
STEP 2 - Connect the Y wire
to the Y terminal on the
thermostat. This connects to
the Cooler compressor.
STEP 3 - Connect the RH wire to the RH terminal
on the thermostat. This connects to the Heater
Power.
STEP 4 - Connect the RC wire to the RC terminal
on the thermostat. This connects to the Cooling
Power.
STEP 5 - Connect the W wire to the W terminal on the thermostat.
This connects to the heater control line.
STEP 6 - Connect the G wire to the G terminal on the Thermostat.
This connects to the Fan.
Your HVAC system is now connected to the thermostat.
Go To Page 10
5 WIRE
NON-HEAT PUMP
NOTE: Wires marked with
the dotted line are optional.
HVAC SYSTEM
Remove
jumper
wire
HEAT
Power
Heat
W G RH RC
C
FAN
Y
Cool
Comp
COOL
Power
Thermostat